Restart on WaveRace

The raw blank with poured rail and outline
Rail made with epoxy and glass balloons
Extra 15mm layer bagged down to first

Overall 5´8" length

Bottom of blank
will shape top side and put rocker in later

The little wonder pump

Bagging the 2 layers of foam together
used epoxy and glass balloon mix to glue together

Waveboard started

Decided to use the "poured edge" technique on this 5ft 8in wave board

I used a simple foam template to route groove.
The template is smaller than board outline by router plate and bit distance.
Only made one half of outline and a tail profile.

Ready for Paint

The fins look lethal

Rocker

3 strips of UD carbon on bottom
3 + 2 on deck

Vacuum Bagging Race Board

All the materials cut and ready to go

Rocker Table with V-bag

Vacuum working
Laminating botton of board first

Weight to hold down board to rocker table

Intalling finboxes

Checking out fin placement

Traifa Fin Company race fins 25 and 10cm, 25 degree cant angle

Looking fast

Gluing with Epoxy

Raceboard inserts

Inserts ready
M6 stainless steel

Set up for 3 footstraps - 2 forward positions